After buying new ballet shoes, you also need to sew a ribbon on your own: at the position of the arch of your foot, sew a ribbon on the left and right sides. Prepare a wide rubber band and sew the two ends together on the heel. This rubber band is not a necessary accessory, but it can help to better fix the shoe on the foot. Some people have very high insteps, and when they are full toes, the heels will often slip off. With this rubber band, this problem is solved.
After the preparations are done, it's time to wear shoes: first wrap a toe cover on your toes. If you have a rubber band, pass the rubber band first, put on your shoes, and place your feet flat on the ground. Adjust the position of the rubber band to the ankle. Then come to tie the ribbon. The ribbon is not as long as possible, nor is it to be wound as many times as possible. First, wrap the ribbon on the side of the arch over the back of the instep and wrap it around the ankle, wrap it around the thinnest part of the ankle, and fix it on the inside; then wrap the ribbon on the outside of the foot in the opposite direction. Note that the ribbon should be completely flat and wrapped around the foot, so that the two ribbons cross on the instep to form a beautiful cross. Finally, tie the two ribbons to the inner side of the ankle with a bow. The knot does not need to be very large, the smaller one is fine. After subtracting the excess ribbon, carefully stuff the knot into the next ribbon. No knots should be seen from any direction. Therefore, the knot should not be too big. If it is too big, it will bulge up and affect the beauty of the entire leg line.
